1685-20
Parallel-Jaw Grip 64 mm Length
- Lightweight, compact grips pull an exceptionally wide range of cable sizes and types
- Designed with a round inside-jaw contour for maximum contact to minimise conductor damage, and a lower serrated jaw to firmly grip insulated cables and conductors
- Design includes a latch that prevents the grip from falling in case of jaw disengagement from the cable
- Large-diameter eye accommodates large hooks on hoists, winches and tackle blocks
- Made in the USA
Lightweight, compact grips pull an exceptionally wide range of cable sizes and types. Designed with a round inside-jaw contour for maximum contact to minimise conductor damage. Lower jaw is serrated to grip insulated cables and conductors firmly. Design includes a latch that prevents the grip from falling in case of jaw disengagement from the cable.
Specifications
Type:
Parallel-jaw Grip
Application:
Wire Pulling
Special Features:
Spring
Overall Length:
9.52'' (24.2 cm)
Overall Height:
5.31'' (13.5 cm)
Overall Width:
1.22'' (3.1 cm)
Material:
Steel
Cable Type:
Messenger, EHS, Coated
Cable Diameter:
0.157'' to 0.875'' (3.98 to 22.22 mm)
Hot Latch:
N
Swing Latch:
N
Spring:
Y
Locking Handle:
N
Jaw Type:
Round
Tooth Type:
Coarse
Jaw Length:
2.5'' (6.4 cm)
Maximum Safe Load:
4500 lb (2041 kg)
Weight:
2.6 lb (1.2 kg)
UPC:
092644471759
Additional Information
Warnings
- Before each use, clean jaw area and inspect grip for proper operation to avoid slippage.
- When used on/near live lines, ground, insulate or isolate grip before pulling.
- Do not exceed rated capacity.
- Always match proper size and type of grip to application.
- Grips are to be used for temporary installation, not for permanent anchorage.
